25 October 2011

Cracked hull filled and smoothed

I filled the prepared area with epoxy mixed with light weight fairing filler (micro-balloons, which I think are miniature glass bubbles) and left that to set. It looks like polyfilla, but as it sets by curing rather than drying I gave it 24hours to set. It is sandable, but much harder than the aforementioned polyfilla. Fortunately I bought a power sander a few weeks ago, so just kept at it until eventually I couldn't feel any roughness or protuberances when I closed my eyes and ran my fingers over it. Fingers are amazingly sensitive. Areas which looked perfectly smooth could feel distinctly rough. I shall prime it and overcoat it and leave it at that, as I plan to sand the whole hull and repaint it later in the winter.

I have got two little LED cabin lights to fix over the fore peak Vee berths. I will need to make a small wooden baseplate for them so that the wires can run in from underneath. The four cabin lights should draw only about 3  watts in total, so my 20Ah battery should be able to cope easily. Interestingly (to me anyway) the solar panel on the cabin roof is showing a charge to the battery just from the daylight coming in through the shed window. It also charges whenever the fluorescent lights are turned on. I have reconnected the battery meter on the switch panel and it shows the battery still as fully charged.

1 comment:

  1. You might qualify for a new government solar program.
    Click here to discover if you are eligble now!

    ReplyDelete